Glitter DTF Pressing Instructions
1. Preparation:
-
Clean and Dry Garment:Ensure your garment is clean, dry, and free from wrinkles.
-
Pre-Press:Pre-press the garment for a few seconds to remove any moisture and wrinkles.
-
Position Transfer:Place the DTF transfer onto the garment with the image facing up (right-reading).
-
Cover with a Protective Sheet:Use a Teflon sheet or parchment paper to protect the transfer and garment during pressing.
2. Heat Pressing:
-
Set Temperature: Set your heat press to 300-320°F (160-177°C).
-
Press for 10-15 Seconds: Apply medium to firm pressure for 10-15 seconds.
-
Allow to Cool Completely: Remove the garment from the heat press and allow the transfer to cool completely before peeling.
3. Cold Peeling:
-
Peel Slowly and Carefully:Once cooled, slowly and carefully peel off the clear film from a corner, starting from a corner with more ink.
-
Avoid Upward Force:When peeling, avoid pulling the film upwards, instead, peel it sideways in a smooth motion.
4. Final Press (Optional):
-
Repress for 5-10 Seconds: Place a Teflon sheet or parchment paper over the transfer and re-press for 5-10 seconds to help seal the design.
Tips for Success:
-
Pre-pressing is Crucial: Pre-pressing removes moisture and wrinkles, ensuring a better transfer.
-
Cool Completely: Allow the transfer to cool completely before peeling to avoid ink lifting.
-
Practice Peeling: Practice peeling on scrap fabric or a test garment to get a feel for the process.
-
Check for Ink Lifting: If you experience ink lifting, try adjusting the temperature, pressure, or pressing time.
- Second Press: A second press with a protective sheet helps to seal the design and can improve durability.
